Note: This item is used equipment. It has been well maintained and is in excellent condition, both cosmetically and technically. Includes original Markbass cover for the Mini CMD 121P. Original packaging not included.
The Mini CMD 121P V offers essentially all the features of the Mini CMD 121P IV, and the price remains the same. The only change is that the amplifier unit—previously based on the Little Mark 4—has been replaced by the Little Mark 58R unit. As with the Little Mark 58R, most controls on the new Mini CMD 121P V are now located on the front panel. The speaker outputs and AC power socket remain on the rear panel. This layout change makes accessing most controls easier.
Specifications:
Power output: 500 W at 4 ohms, 300 W at 8 ohms
Speaker: 1 x 12″ Markbass Neodymium Custom
Tweeter: Piezo
Frequency response: 45 Hz to 18 kHz
Speaker impedance: 8 ohms
Speaker sensitivity: 99 dB
Bass reflex: Rear-facing
Bi-band limiter
Footswitchable (optional): MUTE on/off, SCOOPED-MID / FLAT
Weight: 12.1 kg
Width: 38 cm
Height: 42.5 cm
Depth: 36 cm
Made in Indonesia
Controls:
GAIN
LINE OUT
PRE/POST EQ for LINE OUT (switch on front panel)
GROUND LIFT (switch on front panel)
MUTE SWITCH (switch on front panel and switchable via optional footswitch)
MASTER VOLUME
EQ controls:
LOW: Center frequency 68 Hz; level: ±16 dB
MID LOW: Center frequency 360 Hz; Level: ±16 dB
MID HIGH: Center frequency 800 Hz; level: ±16 dB
HIGH: Center frequency 10 kHz; level: ±16 dB
OLD SCHOOL: Maximum reduction range: 250 Hz – 20 kHz
3-WAY SWITCH: FLAT / SCOOPED MID / FSW (footswitch-controlled function)
SCOOPED MID LED: On/off status indicator
Inputs/Outputs:
INSTRUMENT INPUT
EFFECTS RETURN
EFFECTS SEND
LINE OUT: Balanced XLR
SPEAKER OUT: Speaker Twist jack, 2x 1/4" jacks
Markbass Cover for Mini CMD 121P:
A high-quality, lightweight product like the Mini CMD 121P deserves proper protection. The well-padded cover ensures adequate protection during routine transport—outside of touring scenarios—without significantly adding to the weight. Highly recommended: lightweight and affordable, yet offering a high level of protection. The Markbass cover is made from the following materials:
Outer layer: 600D x 600D PVC polyester
Padding material: 10 mm PUR foam
Lining material: 190T PU nylon
